Street Coilover Kit w/ Camber Adjust Top Mounts (Inox) for BMW 2500-3.3 (E3).
The Street series suspension is the default configuration of MTS Technik engineers, it guarantees a wide range of lowering and a balance between comfort and stiffness.
Suitable for the following engine(s) only:
2.8 L
2500
2800
3.0 L
3.0 S
3.0 Si
3.2 Li
3.3 L
MTS Product SKU: XMTSGWBM50
Tech Specs
| Lowering (Front) | 25 - 85 mm |
|---|---|
| Lowering (Rear) | 30 - 95 mm |
| Series | Street |
| Colour | Inox |
| Max. Load Front Axle | -980 kg |
| Max. Load Rear Axle | -1070 kg |
| With Camber Adjustable Top Mounts (Front) | Yes |
Product Description
 |
2 year warranty with no mileage limit to confirm high quality. |
 |
Suspension components characterized by increased corrosion resistance and made of the highest quality materials. |
 |
The use of twin-tube technology guarantees stable shock absorber performance. |
 |
Pressurised gas presses the hydraulic fluid, eliminating the "foaming" effect of the oil (an undesirable and typical for oil shock absorbers phenomenon), which means higher efficiency for continuous, intensive work. |
 |
Specially selected type of thread and a wide range of suspension adjustment allows optimal setting of the car height. |
 |
The camber plates allow the wheel angle adjustment and increase the precision of driving. |
 |
Innovative hexaCOIL spring perch, significantly increasing the comfort of suspension height adjustment. |
 |
Coilover springs made by Eibach, the world leader in the sport springs industry. |
Additional Notes
Front and rear axle height adjustable (threaded shock absorber housing)
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers
Independent height adjustment at the lower brackets on the front dampers
Set includes 2x upper "camber plates" on the front axle
The installation requires the use of OE front struts - they should be cut and welded as described in the attached manual
In some cases additional OE-parts for the installation of the suspension components are required. Those are not included in the set
Including M-Technik.
